01-31-2004, 12:54 AM
i got the ssautochrome headers and need alittle help figuing out which goes where. does anybody have any good pics of them going together. when i attach them outside of the car it looks like they are off set is this the way they are supposed to be? thanks
01-31-2004, 12:57 AM
best thing to do is put them together in your room, one way they look really offset, the other not so bad
01-31-2004, 01:24 AM
thanks ron i did that and it looks like they will work. i am used to 4 cy and didnt think that they would be off a little due to piston place ment. but i did have it they way that they were really off for a bit. one of the bolts they sent me wont thred can i just go to the auto parts store and get a new one or do i have to contact ssa? thanks
01-31-2004, 01:26 AM
you can go get a new bolt at any store. Actually unless they started replacing them with longer bolts you may need to replace most of thim.
01-31-2004, 01:33 AM
they sent me 4 black ones and 2 gold ones one of the black ones doesnt work. the gold ones might be to short i have it set up in my room and with out the gaskets they are in need of some more room to tighten down good i think. not sure quite yet thought they may work.
01-31-2004, 01:41 AM
add the gaskets and put all together and see. More than likely you will barely be able to get them threaded any nice safe ammount. So I would suggest trying it and then see. It would be better to have the bolts instead of having to go back to the store and get them.