I need a few numbers for my setup ...
1 - Air Temp: Anyone have the voltage setting for temperatures that might be shown.
Example : 32F = .05v and 150F = 4.5v
2 - What about engine temps and voltages
3 - Lastly ... my TPS range is 5.5% closed to 85.5% WOT ... seems a little off.
I need to verify somethings on the TF10 wiring diagram thats being used.
TPS is not wired to the TPS signal but to Analog #2, which in turn uses Analog #2 output to modify the signal to force an open loop condition. This I get.
The MAP sensor is wired into the TPS input and AMP?