** First off, I want to thank Paul J. McCain for the idea as he has done this on his own Tibby **
The total cost of this project was just under $30.
Much cheaper than a $100+ oil catch can.
-Air / Water Seperator (also known as an 'All Purpose Filter') for an Air Compressor.
Coutesy of OZTuscani
This DIY will cover removing the stock Throttle Body (TB) & reinstalling it or replacing it with a BBTB (Big Bore Throttle Body).
12mm Socket, Ratchet, & Short Extension
Rags and/or disposable cup
a. air gun
b. pneumatic socket set
c. T55 torx bit 3/8th inch drive or 1/2 inch if you can find it. we used a 3/8th inch with a hammer ratchet
d. complete set of 3/8th inch drive sockets
e. complete set of 1/4th inch drive sockets
f. variety of phillips head screwdrivers, and...
Ok, closest thing I've found on this forum is the big bore throttle body guide and since removing the throttle body isnt really necessary for replacing your purge control valve, here is a step by step snarky guide on how to do it.
You will need the following tools :
. A car to do this too...
Disclaimer: You don't want to do this. If it's your first time you should know that it will take ten hours of fiddly work, and that paying someone to do this means you don't have to worry about blowing something up when you drive your car. But you're stubborn and motivated and going to do it...