[Faulcun]

Car has solid aluminum mounts. We have an aggressive setup in the car with the clutch. If you are sloppy with with your clutchwork, **** gets violent and this happens...

So, I'm doing this in an attempt to help prevent that from happening again...

Made some 2mm sleeves, and I'm going to Epoxy these in and fill the base area for strength. Yeah. I hope this is overkill.

 

[RetfirDMX]

perfect. any guide on what materials you used for these?

 

[Faulcun]

I just used scrap aluminum rod stock laying around cause aluminum was going to be the easiest to play with on a smaller scale. I spent a ton of time with needle files making the slots fit right.